Installation du système mig, Accessoires en fonction du diamètre du fil, Inbedrijfstelling – Kemppi Promig 520R User Manual
Page 10: Installierung des mig-systems, Zubehör entsprechend dem drahtdurchmesser, Installation of mig system, Accessories corresponding to wire diameter, Installation af mig system, Tilbehør i overensstemmelse med tråddiameter, Installering av mig systemet
10 – PROMIG 520R, 120R / 0544
© KEMPPI OY
20
21 23
24
21
22
25
22
25
– Open tightening lever (20). Remove lower feed rolls (21). Release screw (23) and its washer.
Remove gear wheel D28 (24) from motor shaft.
– Loosen screws (25) (3 pcs) by one twist. Mount D40 gear wheel onto motor shaft. Screw
the screw (23) with its washer back.
– Put feed rolls (21) back on their shafts.
– Lift motor so that tooth gap between gear wheel and both lower feed rolls is approx. 0,2
mm.
– Tighten screws (25). Check gear teeth gaps, if necessary put the motor into a better position.
Screw on mounting screws of feed rolls (22).
Too small a clearance between drive wheel and feed rolls will overload the motor. Too
large a clearance causes rapid wearing of feed rolls’ drive wheel.
3. INSTALLATION OF MIG SYSTEM
3.1. ACCESSORIES CORRESPONDING TO WIRE DIAMETER
PROMIG wire feed rolls are available with plain groove, knurled groove and with U groove.
Feed rolls with plain groove:
Universal feed roll for welding of all kinds of wires.
Feed rolls with knurled groove:
Special feed roll for cored wires and steel wires.
Feed rolls with U groove:
Special feed roll for aluminium wires.
PROMIG wire feed rolls have two grooves. Correct wire groove is selected by moving selecting
washer from over to underneath the feed rolls. Move also drive wheel with the black plastic
washer.
Feed rolls and wire guide tubes of wire feed unit have colour codes to make identification easier.