Installation – Kemppi Pulse TCS User Manual
Page 6

EN
2.
INSTALLATION
2.1
BEFORE USE
KempArc Pulse TCS welding system is delivered in several packages. Product packaging
material is recyclable. Check that you have received following components and that they have
not been damaged during transportation:
• KempArc Pulse TCS 450 A power source (2 pcs)
• KempCool 40 cooler unit (1 pcs)
• Power source fixing plates and their accessories
• DT400 and DT400L wire feeders
• Fieldbus interface card
• TCS cable and interconnection cables (2 pcs)
• Tandem welding torch and its fixing bracket
The detailed parts list can be found in the ordering codes section at the end of this operating
manual.
NOTE!
When moving the welding machine, always lift it from the handle, never pull it from the
welding gun or other cables.
Operating environment
This machine is suitable for both indoor and outdoor use. Always make sure that the air flow to
the machine is unrestricted. The recommended operating temperature range is -20 ... +40 °C.
Please ensure you read the safety instructions concerning operating environments supplied in
this manual.
2.2
MACHINE INTRODUCTION
6,3A
1.
2.
3.
4.
8.
14.
10.
11.
12.
13.
5.
7.
9.
6.
4
KempA
rc P
ulse
TCS / © Kemppi O
y / 1204