Kemppi Pulse TCS User Manual
Page 22

EN
WeldData Delay
Adjustment Range:
1s – 60s
1s steps.
Factory Setting: 20s.
Defines how long the Weld Data is
displayed after Welding Ends.
Weld Data display is also turned off when
pulse encoder is turned or any button is
pressed.
Display Delay
Adjustment Range:
1 – 20
1 steps.
Factory Setting: 10.
Defines how long time the information is
displayed (like: “Setting Saved” text). This is
not always the exact time.
Pre Gas Time
Pre Gas Time setting:
0.0s – 9.9s – CURVE,
0.1s steps.
Factory Settings: CURVE.
CURVE: Pre Gas time is read from the
Welding Curve.
0.0 – 9.9s: User Pre Gas time setting.
Post Gas Time
Post Gas Time setting:
0.0s – 9.9s – CURVE ,
0.1s steps.
Factory Settings: CURVE.
CURVE: Pre Gas time is read from the
Welding Curve.
0.0 – 9.9s: User Post Gas time setting.
ADMINISTRATOR MENU
(In Main menu 2/7, User Identification))
Change
PIN Code
Administrator
pin code change.
Factory PIN
code: 0000
Ask PIN
PIN code inquiry
selection: OFF /
StartUp / Menu
Factory
Setting:
OFF
OFF: No PIN code inquiry.
StartUp: Control panel (K 60) always asks for the PIN code when the
machine is turned on. KF 62 is not affected and always works without PIN.
Menu: Control panel (K 60) asks every time for PIN code when MENU
button is pressed and when the display is in channel info mode i.e. in
start-up view. PIN code inquiry is made only once when entering the
menu. After that the menu button can be pressed any time without PIN
inquiry.
BUTTON FUNCTIONS
ON / OFF Button
Short Press: Panel returns to default start-up display view (Channel info display).
Long Press: When control panel K 60 is ON => Control panel and all KF 62 panels are turned OFF.
When control panel is OFF => Control panel and all KF 62 panels are turned ON.
Pressed while machine is turning ON: Restore to factory shortcut. Panel will ask confirmation to
restore factory setting.
If control panel is OFF and some other KF 62 panel is turned ON the control panel turns also ON and
will be linked automatically to this KF panel (WF# function).
F1 Button
F1 button gives further information of selected memory channel.
Pressed while machine is turned ON: Restore language selection to English.
F3 Button (WF#)
F3 button can be used to select Wire Feeder.
Panel allows selecting only those WF numbers that are found connected on the sys-tem.
Channel +/-
Memory channel selection.
Up/Down Button
Moving Up/Down in menu.
Right/Left
selection buttons
(Soft Keys)
Button function depends on where in menu you are.
20
KempA
rc P
ulse
TCS / © Kemppi O
y / 1204