Kemppi Pulse TCS User Manual
Page 10

EN
2.9
CONNECTING TO MAINS POWER
NOTE!
Always check before use that all cables are in good working condition: the mains cable,
interconnecting cable, shielding gas hose, earth return cable and clamp. Ensure that connectors
are correctly fastened. Loose connectors can impair welding performance and damage connectors.
KempArc power sources are delivered as standard with a 5-meter mains power cable. No
mains plug is fitted at the Kemppi factory.
NOTE!
If local country based regulations state an alternative power cable is required, the mains
cable must be replaced in conformity with the regulations. Connection and installation of the
mains cable and plug, should only be carried out by a suitably qualified person.
Remove the machine cover plate to enable mounting of a mains cable. KempArc Pulse TCS
power sources can be connected to the 3-phase mains supply of 400 V.
If changing the mains cable take into consideration the following:
The cable is entered into the machine through the inlet ring on the rear panel of the machine
and fastened with a cable clamp. The phase conductors of the cable are coupled to supply
terminals L1, L2 and L3. If the cable has also a green and yellow coloured protective grounding
conductor, it should be coupled to the terminal marked with .
If you are using a 5-lead cable, do not connect the neutral conductor.
8
KempA
rc P
ulse
TCS / © Kemppi O
y / 1204