Maintenance – Kemppi Pulse 3000 MVU User Manual

Page 20

maintenanCe

4.1

DailY maintenanCe

NOTE!

Be careful of mains voltage when handling electric cables!

Clean the wire channel of the gun and check the contact tip regularly. Always check the

condition of the mains and welding cable before operation and replace defective cables.

NOTE!

Only a qualified electrician should remove or install the mains cable!

4.2

regular maintenanCe

KEMPPI -service workshops sign special service contracts with customers for regular

maintenance. All parts are cleaned, checked and if necessary, repaired. The operation of the

welding machine is also tested.

4.3

DisPOsal OF tHe maCHine

Do not dispose of electrical equipment with normal waste!
In observance of European Directive 2002/96/EC on waste electrical and electronic

equipment, and its implementation in accordance with national law, electrical equipment

that has reached the end of its life must be collected separately and taken to an appropriate

environmentally responsible recycling facility.
The owner of the equipment is obliged to deliver a decommissioned unit to a regional

collection centre, per the instructions of local authorities or a Kemppi representative. By

applying this European Directive you will improve the environment and human health.

Kempac

t P

y / 1026