Kemppi Pulse 3000 MVU - Manual (Page 15)

EN
Fe-group
F1 F1 F1 0,8 mm Fe Ar + 18 % CO²
F2 F2 F2 0,9 mm Fe Ar + 18 % CO²
F3 F3 F3 1,0 mm Fe Ar + 18 % CO²
F4 F4 F4 1,2 mm Fe Ar + 18 % CO²
F5 0,8 mm Fe CO²
F6 0,9 mm Fe CO²
F7 1,0 mm Fe CO²
F8 1,2 mm Fe CO²
FA FA FA 1,0 mm FeMC Ar + 18 % CO²
FB FB FB 1,2 mm FeMC Ar + 18 % CO²
FD 1,2 mm FeFC Ar + 18 % CO²
Auto
20 20 1,0 mm CuSi3-A Ar 1,1 – 2,0
1 21 21 1,0 mm CuSi3-A Ar 2,0 – 2,6
2 22 22 1,0 mm CuSi3-A Ar 2,4 – 3,1
3 23 23 1,0 mm CuSi3-A Ar 3,0 – 3,6
4 24 24 1,0 mm CuSi3-A Ar 3,5 – 4,1
5 25 25 1,0 mm CuSi3-A Ar 4,0 – 4,6
6 26 26 1,0 mm CuSi3-A Ar 4,5 – 5,1
7 27 27 1,0 mm CuSi3-A Ar 5,0 – 5,5
8 28 28 1,0 mm CuSi3-A Ar 5,5 – 6,0
9 29 29 1,0 mm CuSi3-A Ar 6,0 – 6,5
10 30 30 1,0 mm CuSi3-A Ar 6,4 – 7,0
11 31 31 1,0 mm CuSi3-A Ar 6,9 – 7,6
12 32 32 1,0 mm CuSi3-A Ar 7,4 – 8,1
3.3.4 adjustments, display and weld data
Display for welding current and welding material thickness. Changing can be made using the
button behind the display. There is a percentage display (eg. gas consistency) and seconds
display (see timer). The relative length of arc will be displayed when adjusted. Otherwise the
predicted current value is displayed (not in 2-MIG).
Process Manager™ for setting all welding parameters.
The display for wire feed speed, welding voltage or material group. This can be switched using
the button under the display (wire feed speed/length of arc). The voltage can be adjusted
in the normal and 1-MIG position (wire feed range/the length of arc). During pulse welding
the voltage is determined by the wire feed speed while the length of arc affects some other
parameters.
When pressed simultaneously, the weld data buttons recall the wire feed speed on the display,
the welding voltage and welding current values which have been used when welding was
stopped.
13
Kempac
t P
ulse 3000 MVU / © Kemppi O
y / 1026