beautypg.com

Kanguru QSX User Manual

Page 8

background image

8

2.3 Setting the Storage mode

You can configure the way the Kanguru QSX operates by adjusting the dip switches located on the

back of the unit (see section 2.1 Parts and Functions, p.6). The Kanguru QSX can be configured to

operate in any one of the following 4 storage modes:

BiG -

Combines two physical hard drives into a single volume (see section 3.1 BIG, p.14).

JBod -

Each hard drive operates as an independent drive (see section 3.2 JBOD, p.15).

raid1 (Safe) -

Saves all data in duplicate on separate drives in a mirrored array to protect

against data loss due to drive failure (see section 3.3 RAID1 (SAFE), p.16)

raid0 (faSt) -

Distributes data across both hard disks in a striped array. This allows for

improved read/write transfer rates. (see section 3.4 RAID0 (FAST), p.17)

Storage modes can be changed by adjusting the position of the dip switches. it is Not recommended

to switch between storage modes after you have begun saving data to the Kanguru QSX.

Switching storage modes may require that you reformat your hard drives which will cause all data on

the hard drives to be erased.

To set the storage modes:

Make sure the Kanguru QSX is switched off.

1.

Use a straightened paperclip or similar long, thin object to set a dip switch in either to the Up (0)

2.

position or Down (1) position.

ON DIP

N/a

0

1

Note: The switch furthest to the right is not used. Its position will not affect the storage mode.

The available storage mode settings are as follows:

BiG

000

JBod

001

raid0 (faSt)

010

raid1 (Safe)

011

Turn the power switch to the On position then press the reset button. You may need to use the

3.

same thin object to press the reset button.

Basic Operation