JLCooper BTX Eclipse - Manual (Page 8)

8
1. While the unit is powered, hold down the SHIFT key and
press the ASSIGN/UTILITY button.
2. The current IP Address will be shown in the display. If you
do not wish to change this address, press ENTER.
3. If you wish to change this, press numeric pad keys. This
does not scroll. If you make a mistake, press the CLEAR
button once, and the current number will reappear.
4. When satisfied with the displayed value, press the ENTER
key. The display will then display the Gateway value. If
you don't wish to change this, press ENTER again. Press
ENTER again to step past the Subnet Mask.
5. The Port number will now appear as a five-digit number. If
you do not wish to change it, press ENTER. If you do wish
to change it, it must be entered as a five-digit number. For
instance, if you wish for port #80, you must enter 00080. If
a mistake is made, press the CLEAR button once.
6. After the ENTER key is pressed this last time, the changes
will be made to internal non-volatile memory, and a
message will appear.
As the message indicates, the changes will not take place on the
Ethernet Card until the power has been turned off and back on.
If you cannot access the Eclipse BTX, please refer to the
troubleshooting section.