JLCooper BTX Eclipse - Manual (Page 17)

17
Solution
Set the ethernet settings on your Eclipse BTX and PC to work
together.
For example, with the Eclipse BTX factory defaults of:
IP Address 192.168.254.101
Subnet Mask 255.255.255.0
Gateway 192.168.254.198
Set your PC ethernet settings to:
IP Address 192.168.254.nnn
Subnet Mask 255.255.255.0
nnn is anything except 101
Note: You can verify that the computer can communicate with the
Eclipse BTX by pinging the Eclipse BTX. In Windows, click Start |
Run… and type:
ping 192.168.254.101 . If everything is configured
correctly, the Eclipse BTX will reply.
Issue
I still can’t connect to Eclipse BTX with the host software.
Cause
There may be another device on the network that uses the same
address as the Eclipse BTX.
Solution
Change the IP address of the conflicting device or remove the
conflicting device.
Issue
Can’t connect to Eclipse BTX with the host software behind a
router.
Cause
An ethernet router may block and/or translate ethernet traffic.
Solution
Ask your network administrator for assistance. If the Eclipse
BTX is set as a server and is behind a router, you will need to
perform port forwarding. Configure your router to forward TCP
traffic on one port to the IP address and port number of your