JLCooper BTX Eclipse - Manual (Page 13)

Technical Reference
Ethernet Interface
The Ethernet Interface is intended for operation with a host
computer. It provides the advantages of a standard interface, long
cable runs, use over private/public/wired/wireless networks, the
ability of being shared among computers and the ability to work
with any platform that supports TCP/IP.
The Ethernet interface in the Eclipse BTX is a standard auto
switching 10baseT/100baseTX, twisted pair interface with an RJ-
45 connector. Use a straight through cable to connect the Eclipse
BTX to an Ethernet hub or switch. Use a crossover cable to
connect the Eclipse BTX directly to a host computer.
Power
The Eclipse BTX requires a 12 volt DC, center pin positive, power
supply capable of delivering at the m
, 5 amps. The unit
comes with a power supply (JLCooper part number 561024-3
you need a power supply specific to your location, please contact
your local distributor or JLCooper Electronics.
inimu
). If
arning: using a power supply other than, the unit specified could
m
W
result in damage to the Eclipse BTX and/or other equipment, which is
not covered by the JLCooper Factory Warranty.
13