JLCooper eBOX GPI8 - Manual (Page 27)

27
eBOX GPI8 IP address
This is the IP address of the eBOX GPI8 you want to test.
eBOX GPI8 TCP Port
This is the TCP port of the eBOX GPI8 you want to test. The
eBOX GPI8 TCP port in the server mode is TCP port 23 by
default. This can be configured for any TCP port.
Connection State
This window shows the status of the connection to the eBOX GPI8
you want to test.
Connect / Disconnect
This allows you to establish or break the connection to the eBOX
GPI8 you want to test.
Status Window
This window shows additional status messages of the connection
to the eBOX GPI8 you want to test. In addition, you will also see
the firmware version of the connected eBOX GPI8.
GPI Inputs
These checkboxes indicate the state of the input pins on the GPI
Input connector. A check mark indicates that the corresponding
pin is in the active state (logic low or 0 volts). The absence of a
check mark indicates that the corresponding pin is in an inactive
state (logic high or 5 volts). Clicking on a checkbox will cause the
eBOX GPI8 GPI Tester Utility to send a GPI Query command to
update the state of the checkbox.
GPI Outputs
Sets selected GPI Output to active state (logic low or 0 volts). All
other GPI Outputs are set to inactive state (logic high or 5 volts).
All Off
Sets all GPI Outputs to inactive state (logic high or 5 volts).