JLCooper eBOX GPI8 - Manual (Page 13)

13
eBOX GPI8 to Configure
In this section, enter the IP Address, TCP Port and Password of the
target eBOX GPI8 that you wish to configure.
IP Address
This is IP Address of the target eBOX GPI8 to configure.
TCP Port
This is the TCP Port of the target eBOX GPI8 to configure. The
TCP Port for configuration is fixed at 4141. In most
circumstances, you will never have to change this however, if the
eBOX GPI8 is behind a router using port forwarding, you may
have to specify a different port.
Password
If DIP switch 6 is set to the down position, the eBOX GPI8 uses a
password to prevent unauthorized access. The default password is
‘password’.
Note: If the Password box contains any text, the eBOX GPI8
Configuration Utility will pad out the password with spaces and
truncate the password to 8 characters. If the Password box is empty,
the eBOX GPI8 Configuration Utility will send no password.
eBOX GPI8 Password Change
This section allows you to change the password of the eBOX
GPI8. Remember, if DIP switch 6 is set to the down position, the
eBOX GPI8 requires the correct password in the ‘eBOX GPI8 to
Configure’ section. The default password is ‘password’.
New Password
This is the area to enter a new password. The password can be up
to 8 characters in length.
Update Password
Clicking on this button sends the new password to the eBOX GPI8.
Note: The eBOX GPI8 Configuration Utility will pad out the password
with spaces and truncate the password to 8 characters even if the
Password box is empty.