beautypg.com

Ips e.max – Ivoclar Vivadent IPS e.max Clinical Guide User Manual

Page 32

background image

32

IPS e.max

®

lithium disilicate hybrid abutment

and crown cemented with SpeedCEM

®

The abutment is screwed-in.

SpeedCEM

®

is dispensed from the automix syringe

and the desired amount is applied directly on the
restoration.

A thin layer of Monobond

®

Plus is applied on the

abutment and allowed to react for 60 seconds.
Subsequently, the abutment is dried with
moisture- and oil-free air.

The permanent restoration is tried-in. The shade, fit
and occlusion of the restoration are now checked.

The restoration is seated and held in place
maintaining stable pressure.

Etching is performed with 5% hydrofluoric acid
(e.g. IPS

®

Ceramic Etching Gel) for 20 seconds.

Next, the preparation is rinsed thoroughly with
water and dried with oil-free air.

The abutment is cleaned with a polishing brush
and an oil- and fluoride-free cleaning paste (e.g.
Proxyt

®

). Subsequently, it is rinsed with water spray

and dried with oil-free air.

Excess cement material is light-cured with a poly-
merization device (e.g. Bluephase

®,

approx.

650 mW/cm

2

, LOW mode) for 1 second per quarter

surface at a distance of approx. 0 – 10 mm.

Monobond Plus is applied on the pretreated
surface, allowed to react for 60 seconds and
thoroughly dispersed.

LS

2

Dr Ronny Watzke / Jürgen Seger (DT), Principality of Liechtenstein