Ivoclar Vivadent IPS e.max Clinical Guide - Manual (Page 26)

26
IPS e.max
®
lithium disilicate posterior crown
cemented with Multilink
®
Automix
The preparation is cleaned with a polishing brush
and an oil- and fluoride-free cleaning paste (e.g.
Proxyt
® fluoride-free). Subsequently, it is rinsed with
water spray and dried with oil-free air.
Subsequently, the preparation is thoroughly rinsed
with water spray...
The permanent restoration is tried-in in the
non-crystallized state. Any adjustments of the
occlusion contacts can be easily performed before
crystallization.
Subsequently, the combination firing (crystallization,
glaze) is performed.
...and dried with oil-free air.
Etching is performed with 5% hydrofluoric acid
(e.g. IPS
® Ceramic Etching Gel) for 20 seconds.
Monobond ® Plus is applied on the pretreated
surface, allowed to react for 60 seconds and then
thoroughly dispersed with air.
LS
2
Dr Arnd Peschke, Principality of Liechtenstein / Chairside