Ivoclar Vivadent IPS Empress Esthetic Speed User Manual
Page 4
4
To ensure thorough heating of the investment rings in the preheating furnace, the following points
have to be observed:
– Load the preheating furnace to maximally half of the available utility space.
– Always place the investment rings in the rear part of the preheating furnace.
– Place the investment rings as quickly as possible in the preheating furnace. Make sure that the furnace
temperature does not drop substantially.
– Always place the investment rings in the preheating furnace with the opening facing down.
– If more than two 200-g investment rings have to be preheated in the preheating furnace, we recommend
investing them consecutively and placing them in the preheating furnace at an interval of approximately
20 minutes.
– Do not place the investment rings in direct contact with each other. Allow air circulation.
IMPORTANT! Safety notes
– Do not open the furnace during the first 20 minutes of preheating: Burn hazard caused by wax fumes that
might ignite in the air!
– This material contains quartz, which may cause lung diseases (silicosis or cancer) when inhaled. Prevent
the inhalation of dust and wear a suitable dust mask.
Physical data
(according to ISO 15912:2006)
– Flow characteristics:
110 mm
Liquid concentration 50%
– Initial set:
10.5 minutes
Liquid concentration 50%
– Compressive strength:
5 MPa
Liquid concentration 50%
– Linear thermal expansion:
0.9 %
Liquid concentration 50%
This material has been developed solely for use in dentistry. Processing should be carried out strictly according to the Instructions for Use.
Liability cannot be accepted for damages resulting from failure to observe the Instructions or the stipulated area of application. The user is
responsible for testing the products for their suitability and use for any purpose not explicitly stated in the Instructions. Descriptions and data
constitute no warranty of attributes and are not binding.