Ivoclar Vivadent IPS d.SIGN - Manual (Page 18)

18
IPS d.SIGN Opaquer Liquid, 15 ml
This liquid is used to adjust
the consistency of IPS d.SIGN
Paste Opaquer materials. Do
not excessively dilute the
paste opaquer with the
opaquer liquid.
Components: Polymer,
butylene glycol, and
glycerine
IPS d.SIGN Build-Up Liquid Medium, 60 and 250 ml
This liquid is suitable for
mixing IPS d.SIGN materials
for most layering techniques
and restorations. The Build-
Up Liquid Medium is particu-
larly suitable for technicians
who prefer a longer working
time and enhanced stability
of IPS d.SIGN. In this way,
IPS d.SIGN may be processed
in smaller increments, with-
out the constant need of
moistening. Given the longer
working time than with the
Build-Up Light, a longer
closing time (pre-drying time)
IPS d.SIGN Margin Build-Up Liquid, 60 ml
Use to mix the IPS d.SIGN
Margin materials.
Components: Water,
cellulose derivative
d.SIGN – Liquids
IP
S
Warning
Butylene glycol is irritating. Avoid contact. Do not
inhale vapours.
IPS d.SIGN Build-Up Liquid Light, 60 and 250 ml
This liquid is suitable for
mixing IPS d.SIGN materials
that will be used for smaller
restorations or when smaller
amounts of material are
needed for 2nd dentin and
incisal firings (corrective
firing). The Build-Up Liquid
Light is suitable for those
who prefer a drier working
consistency, thus avoiding
the need for constant
blotting since the liquid
evaporates much quicker. In
this way, IPS d.SIGN can be
IPS d.SIGN Build-Up Liquid Premium, 60 and 250 ml
This liquid is suitable for
mixing IPS d.SIGN materials
that will be used for
fabricating larger restorations
where a longer working time
and smooth consistency is
desired. The Build-Up Liquid
Premium is suitable for
technicians who prefer a
long working time and moist
material coupled with high
stability. In this way,
IPS d.SIGN can be processed
without the need for
constant moistening. Since
the material stays moist for a
longer period of time
controlled blotting is
IPS d.SIGN Glaze and Stain Liquid, 15 ml
This liquid is used to adjust
the consistency of IPS d.SIGN
Stains, IPS d.SIGN Shade,
IPS d.SIGN Essence, and
IPS d.SIGN Glaze.
Components: Butylene
glycol
is required for the firing
procedure.
Components: Water,
butylene glycol, and
additives
easily manipulated with an
instrument.
Components: Water,
butylene glycol, and
additives
required as well as a longer
closing time (pre-drying
time) for the firing
procedure.
Components: Water,
butylene glycol-chloride
solution
The Opaquer Liquid must not be used to mix
opaquers, as it is the case in power/liquid opaquer
systems.