beautypg.com

Infloor PAP Press Tool 24535 and 24538 User Manual

Page 7

background image

7

C, Close the pressing tool and tighten up the "locking screw" (Part No. 13) clockwise,then open the

pressing tool,the adjustment is finished.

D, For pressing fittings 3/4" and 1 ” , the lengthened handles (Part No.12) should be mounted

after adjustment.

Lengthened handles are not necessary when pressing fittings no bigger than 5/8”. Lengthened

handles are only necessary for pressing fittings 3/4" and 1" .

4,Cautions and parameters for pressing tool adjustment

(1) Adjustment should be made on the following occasions:

New pressing tool is to be used.

Pressing tool jaws can not be fully closed when pressing fittings.

Change pressing jaws,

User finds that Operation Force changes a lot in pressing fittings than before.

Closed pressing tool can be openned freely without using any force.

Pressing effect is bad.

(2) In case of new tools,due to the burrs in tool production, Operation Force change after 60 times

of pressing is possible but is normal,the tool can still be used after proper adjustment.

(3) After adjustment, Operation Forces for pressing fittings could refer to following table.

Note:The forces listed above are for pressing fitting 1 / 2 ” without lengthend

handles, and for pressing fittings 3/4" and 1" mounted with lengthened handles.

5, Special operations at corners or narrow spaces

Specification 16 1/2”

25 3/4”

32 1”

Operation

Force (pounds) 44 LBS 88 LBS 99 LBS

Infloor Sales & Service adjustable manual pressing tools provide special design for occasions

where there isn’t enough space to open the handle or lengthened handles such as corners or narrow

spaces. In this case, you can operate as below steps: