Infloor PAP Press Tool 24535 and 24538 - Manual (Page 5)

5
Step2, Mount appropriate pressing jaws on to pressing tool
A, You need to open the pressing tool handles and then take off two screws (Part No.1,M6×25), see
following picture.
B, Position the two opposite jaws in the pressing tool head, make sure the two jaws are evenly well
positioned and the specification number on the two jaws are on the same side, then fix the jaws with
the screws (Part No.1,M6 x 25).
Note:please don't over tighten the jaws, little looseness is allowed
C, Please pay attention to the jaw positioning, make sure the center of pressing hole formed by these
two opposite jaws is by the jaws openning direction rather than the handles opening direction.
D, Trial-Pressing-Force evaluation
Try to close the pressing tool without fitting and lengthened handles mounted, the appropriate Trial-