Hypertherm Powermax30 XP Service Manual - Manual (Page 41)

Powermax30 XP Service Manual 808150 Revision 1 41
4 – Operation
Operate the Powermax30 XP
The following topics explain how to begin cutting with the Powermax30 XP.
Connect the electrical power and gas supply
Plug in the power cord and connect the gas supply line .
 For information on connecting the gas supply to the power supply, see Prepare the gas supply on page 29.
 For information on connecting the proper plug to the power cord, see Power cord considerations on page 26.
 To understand which consumables to use and what cutting capacity to expect based on input voltage, see Choose
the consumables on page 32.
 For information on electrical requirements and gas supply requirements for this system, see Power Supply Setup on
page 23.
1 2
1
2