Hypertherm Powermax30 XP Service Manual - Manual (Page 34)

34 Powermax30 XP Service Manual 808150 Revision 1
3 – Torch Setup
General-purpose (standard) consumables
Use the general-purpose (or standard) consumables to cut thicker metals that do not require cuts that are as finely
detailed. (See
Voltage configurations on page 25 and System operation guidelines on page 47.) This set includes an
electrode, swirl ring, general-purpose nozzle, retaining cap, and shield. The general-purpose nozzle must be installed only
with the shield, not the deflector.
Cutting at 120 V with the general-purpose consumables is not recommended.
Figure 3 – General-purpose (standard) consumable set
* Order the general-purpose (standard) nozzle and electrode together using kit 428243. This kit contains 2 nozzles and 2 electrodes.
Replace the nozzle and electrode at the same time.
5 4 3 2 1 6
1 Torch
2 Electrode (420120)*
3 Swirl ring (420211)
4 Nozzle (420118)*
5 Retaining cap (420114)
6 Shield (420116)