Hypertherm Powermax30 Operator Manual - Manual (Page 82)

MAINTENANCE AND PARTS
1
5-8
powermax30
Operator Manual
Replacement
1. Hold the Nomex barrier so that the edge
with the long cutout and 2 small notches
is on the left and the edge with 3 notches
is on the right.
2. There is a perforation across the top,
about 1inch down from the top edge. If
you are replacing the Nomex barrier with
a new one, you will need to fold it along
this perforation so that the top edge
bends away from you.
3. Position the barrier so that the edge with
the long cutout is toward the front (torch
end) of the power supply. Slide the
barrier into place with the bottom edge in
the same track the cover rests in. The
notches on each edge of the barrier
should align with the ribs on the inside of
the endcaps.
4. Being careful not to pinch any of the
wires, slide the cover back onto the
power supply. Make sure that the bottom
edges are in the tracks and that the slot
in the top of the cover lines up with the
tab on the front endcap. . Position the
handle over the holes in the top of the
cover, then use the 2 screws to secure
the cover.
Long cutout
Track
Cover slot
Tab
PMX30_OM_05.qxp:PMX30_OM_05 10/7/09 12:46 PM Page 5-8