Hypertherm Powermax30 Operator Manual - Manual (Page 56)

SETUP
2
3-2
powermax30
Operator Manual
Unpack the Powermax30
1. Verify that all items on your order have been received in good condition. Contact your distributor
if any parts are damaged or missing.
2. Inspect the power supply for damage that may have occurred during shipping. If there is
evidence of damage, refer to Claims, below. All communications regarding this equipment must
include the model number and serial number located on the bottom of the power supply.
3. Before you set up and operate this Hypertherm system, read Section 1, Safety.
Claims
• Claims for damage during shipment – If your unit was damaged during shipment,
you must file a claim with the carrier. Hypertherm will furnish you with a copy of the bill
of lading upon request. If you need additional assistance, call the nearest Hypertherm office
listed in the front of this manual.
• Claims for defective or missing merchandise – If any component is missing or
defective, contact your Hypertherm distributor. If you need additional assistance, call
the nearest Hypertherm office listed in the front of this manual.
Contents
Verify the items in the box against the illustration.
Note: If you purchased the Powermax30 with the deluxe carrying case, your package will include
the case, 3 electrodes, 3 nozzles, a swirl ring, a retaining cap, a deflector, silicone
lubricant, 3 o-rings, gloves, and a plasma cutting guide in addition to the consumables
holder, air fitting reducer (1/4 FPT x 1/8 NPT), Operator Manual, Quick Setup Card, and
Product Registration Card.
Operator Manual
Quick Setup Card
Product Registration
1
1
1
(CSA)
(CE)
or
Consumables
holder
Strap
PMX30_OM_03.qxp:PMX30_OM_03 10/7/09 12:44 PM Page 3-2