Dimplex Electric Fireplace DFG3033 - Manual (Page 11)

11
Operation
Electric Fireplace Manual
Control
The manual controls for the
fireplace are located in the upper
right hand corner (Figure 5).
A. Main On/Off Switch
Supplies power to the 3 Position
Manual Control Switch.
B. 3 Position Manual Control
Switch
Remote (left position): The
unit is operated with the remote
control.
Flame (center position): The
flame effect is turned on.
Flame & Heat (right position):
The flame effect and heater are
turned on simultaneously. When
the manual control is in the Flame
Figure 5
A b C
& Heat position the heater does
not run on the remote operated
thermostat.
!
NOTE: When the manual
control switch is in the Flame
or Flame & Heat positions, the
fireplace unit will not operate
with the remote control.
C. Initialization Button
Used to synchronize the remote
control with the fireplace.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset.
The temperature cutoff switch
can be reset by unplugging the
unit, waiting five (5) minutes and
plugging the unit back in.
CAUTION: If you need
to continuously reset the
heater, unplug the unit and
call Dimplex North America
limited at 1-888-346-7539
for technical support. Please
have your model and serial
number ready when calling.