Gullco GK-200-RLx-A - Manual (Page 7)

5
The following provides a brief description of the GSP-2100 controls (refer to the above sketch):
The Cycle Push Button – is a momentary device, which when pressed for one second while the
Run/Stop switch is in the Stop position and the Fwd/Neut/Rev switch in the Rev position, will toggle
between Manual Mode (Hnd) and Automatic Mode (Aut). When in Automatic Mode the Auto Cycle
Mode LED will be illuminated.
The Cycle Push Button is also used to access the motor control variable
parameter settings and the welding variable parameter settings (refer to the section “Programming The
Automatic Cycle Parameters/Variables” later in this manual for further details of this function). The cycle push
button is also used to reset error codes once they have been rectified (refer to the section “Error Codes” in the
GSP-2100 technical manual, GD-075)
The Run/Stop Switch – is used to start and stop the AutoWeld “KAT”
®
carriage in either Manual
Mode or Automatic Mode.
The Forward/Neutral/Reverse Switch – is used to select the travel direction desired in both Manual
Mode and Automatic Mode.
When used in conjunction with the speed adjustment knob, the forward or
reverse position is used as the method of changing the values/settings of the program variables (refer to the
section “Programming The Automatic Cycle Parameters/Variables” later in this manual for further details of
this function).
The Speed Adjustment Knob - is used to increase (clockwise) or decrease (counter-clockwise) the
travel speed of the carriage, both in Manual Mode and Automatic Mode. In automatic mode, the
carriage will travel at full speed during the no-weld part of a stitch cycle, during an advance to weld
start location, during an automatic return to the park position and when traveling in the opposite
direction to that set by the Weld Direction parameter (unless the Continual Forward & Reverse
feature is active). The speed display will show the set speed when the Run/Stop switch is in the
Stop position and the Forward/Neutral/Reverse switch is in the Neutral position.
Speed & Parameter Value
Display
Speed Display Calibrated in
Inches per Minute
Speed Display Calibrated in
Centimeters per Minute
Auto Cycle Mode (Constant)
Manual Mode (Absent)
Speed Adjustment
Counter-Clockwise = Slower
Clockwise = Faster
Neutral
Command Reverse Motion
Control in Run Mode
Cycle Push Button
Arc Signal Active
Hold (Stop) Mode Active
Reverse Motion Commanded
Forward Motion Commanded
Control in Hold (Stop) Mode
Command Forward Motion