Gullco GK-200-RLx-A - Manual (Page 16)

14
Example 7:
Setting 4 = Fwd & Rev
Setting 5 = - - -
Setting 6 = - - - Setting 1 = 1 Second
Setting 2 = 0.5 Seconds
Setting 3 = - - -
R.L.S.
Off
Rev
Fwd
Sp
ee
d
Tr
ave
l
On
S1
Time
Arc Signal Relay
Setting 7 = - - -
Setting 8 = - - -
Setting 9 = On
F.L.S. R.L.S. F.L.S. R.L.S. Stop
S2
The following label is applied to each AutoWeld “KAT
”
®
carriage to graphically identify the individual
programmable parameters/variables:
P1 = Travel Motion Delay
P2 = Crater Fill Delay
P3 = Post Weld Delay
P4 = Weld Direction
P5 = Advance To Center Limit Switch
P6 = Stitch Weld Selection
P7 = No-Weld Spacing (Stitch Weld)
P8 = Weld Back Track
P9 = Automatic Return To Home
P10 = Continual Forward & Reverse
Setting 1 = 1 second Setting 4 = Fwd & Rev Setting 7 = --- Setting 10 = On
Setting 2 = 0.5 seconds Setting 5 = --- Setting 8 = Off
Setting 3 = --- Setting 6 = --- Setting 9 = ---