Gullco GM-03-300 - Manual (Page 14)

12
P. 4 GM-03-350 - Not Available.
GM-03-300 – Stitch Weld - Enables/disables stitch welding and specifies length of each
weld stitch. When OFF is selected the weld will be continuous. A numerical value
specifies the distance in inches or cm (dependant upon the unit calibration of the
control) that the carriage will travel during a stitch weld.
P. 5 GM-03-350 - Not Available.
GM-03-300 – No-Weld Spacing - Specifies the distance in inches or cm (dependant
upon the unit calibration of the control) that the carriage will travel between stitch
welds. If the Stitch Weld parameter is set to “Off”, then this parameter is disabled
(forced to Off) and the display variable will show “- - -“.
Factory Settings:
The following table shows the settings/values of the Programmable Parameter/Variables as
supplied from the factory:
Switch
Position
Parameter
GM-03-350
(GSP-2004-9)
Value GM-03-300
(GSP-2004-10)
Value
P. 1 Travel Motion Delay 00.3 (seconds) 00.3 (seconds)
P. 2 Crater Fill Delay 00.5 (seconds) 00.5 (seconds)
P. 3 Post Weld Delay - - - 01.0 (seconds)
P. 4 Stitch Weld Selection - - - Off
P. 5 No-Weld Spacing - - - - - -
P. 6 Not Applicable - - - - - -
P. 7 Not Applicable - - - - - -
P. 8 Not Applicable - - - - - -
P. 9 Not Applicable - - - - - -