Grip Factory Munich GF-Quad Dolly - Manual (Page 21)

- 20 -
Connection
holes for
push bar
Locking
knob/bolt
6.6 Push bar
The push bar provides the means to better control faster dolly movements. As
the width of the push bar is adjustable, it can be set at the right width for
narrow doorway shots or fast tracking moves.
To mount the push bar on the dolly please proceed as follows:
Insert the push bar into the respective connection holes found at either
the front or rear end of the dolly.
Secure the push bar with the 2 locking knobs/bolts to avoid unwanted
play or removal .
Positioning and securing the push bar
When using the dolly with push bar in doorways or passages narrower than
1,05m the push bar should either be removed or set in the narrowest position
to avoid a collision.
To adjust the push bar, please proceed as follows:
Remove the locking pin by firstly unscrewing it from the bar and then by
pressing and holding down the release button to take it out of the hole.
Extend the push bar until, both the hole in the inner and the outer tube
overlap.