Grandstream Wave - Manual (Page 60)

Firmware Version 1.0.1.21 Grandstream Wave User Guide Page 59 of 64
Config Server
Path It is used to define IP address or URL for the server.
Grandstreeam Wave could obtain the configurations
from the server path automatically.
Export
Configuration It is used to export the configuration files to the path
on the phone: /sdcard/ GS Wave/ config.
BLF (Busy
Lamp Field)
If enabled, Grandstream Wave will detect the status
of the Contacts in the BLF list.
There are 3 statuses.
:
Offline. The contact is not online or
unregistered.
: Busy. The contact is in an active call.
: Online. The contact is in idle.
NOTE: The server should support BLF function if
enable BLF.
BLF List It is used to add participants and display the online
status. Users could view the online status in the SIP
Contacts, as shown in figure 47.
LDAP
Settings Tap to access the LDAP Settings screen to set up features. Users could set by QR Code
Scan, Select QR Code Image or Manual Settings.

Tap on "QR Code Scan" to access QR code scan screen, scan the QR code which
contains LDAP information sent by the UCM server to configure LDAP settings.

Tap on "Select QR Code Image" to access screen with QR code image, select the
image which contains LDAP information to configure LDAP settings.

Tap on "Manual Settings" to access screen as shown in figure 48.