beautypg.com

Advanced settings, General settings, Table 9: advanced settings – Grandstream Wave User Manual

Page 56: General settings parameters

background image

Firmware Version 1.0.1.21

Grandstream Wave User Guide

Page 55 of 64

DTMF

Users can choose different ringtones.

This parameter specifies the mechanism to transmit
DTMF digits. There are 3 supported modes:

• In audio, which means DTMF is combined in the

audio signal (not very reliable with low-bit-rate
codecs);

• RTP (RFC2833), which means to specify DTMF

with RTP packet. Users could know the packet is
DTMF in the RTP header as well as the type of
DTMF;
• SIP INFO. Use SIP info to carry DTMF. The defect
of this mode is that it's easily to cause desynchrony
of DTMF and media packet for the reason the SIP
and RTP are transmitted respectively. The default
setting is "RFC2833".

Preferred
Vocoder

It is used to configure whether to enable Dialplan.

Multiple vocoder types are supported on the phone,
the vocoders in the list is a higher preference. Users
can configure vocoders in a preference list that is
included with the same preference order in SDP
message.

SRTP Mode

The default setting is "Disable". Users could choose "Enable and Force" which
means enable and force to use SRTP; "Enable But Not Force" means enable but
not force to use SRTP.

Enable

SRTP

Key Life Time

It is used to configure whether to enable SRTP key life time. If enabled, the RTP
packets received and sent during the call cannot exceed 231. The default setting is
"Yes".

ADVANCED SETTINGS

Advanced Settings include General Settings, Call Settings, Audio Settings, Network Settings and

Additional Settings.

GENERAL SETTINGS

Table 9: Advanced SettingsGeneral Settings Parameters

Edit

Before

Dial

It is used to configure whether to edit number before
dial. If set to "No", tap on the contact or one call
history entry on call screen to dial out with the last
dial-out account directly. If set to "Yes", when tap on
the contact or one call history entry on call screen,
the phone will automatically fill in the corresponding
number to the input box, users could edit the number
before dial out.

Default
Account
Registration
Notification

It is used to define whether to enable registration
notifications for default account. If enabled, users will
see the notifications in the status bar once the default
account status is changed.

Vibrate When It is used to configure whether to vibrate when