GAI-Tronics XCP0050A Supervisory Control Kit - Manual (Page 2)

Pub. 43003-016B
Model XCP0050A Supervisory Control Kit Page: 2 of 3
11/02
4. Attach the supplied ground cable to the quick-disconnect on the rear of the Supervisory unit. Attach
the other end to the ground screw on the rear cover of the base unit. Bend the tab on the quick-
disconnect on the rear of the Supervisory unit to allow it to sit flush when seated on the connectors.
5. Pull the supervisory cable through the rectangular cut-out on the rear cover, and connect it to P17 on
the main control PCBA in the ICP9000 Series Desktop Console.
6. Reattach the ribbon cables (SLV-CBL-P) to their matching connectors, and reattach the rear cover.
7. Assemble the Supervisory unit by inserting the two locating tabs into their matching slots on the rear
cover, and attaching it with the four supplied #6-32 pan head machine screws.
8. Reattach all cables and reconnect the power.
9. Refer to the CARD Suite software (XAC1000A) for specific programming instructions for
reconfiguration.
Exploded View of the ICP9000 Series Console Rear Panel