GAI-Tronics 12519-002 Hook Assembly Kit (700 Series) - Manual (Page 2)

Pub. 42003-039A
M ODEL 12519-002 S TATIONARY C RADLE A SSEMBLY R EPLACEMENT K IT Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-039a.doc
3. Separate the chassis from the front panel.
4. Remove the two screws holding the cradle on the panel. Note the purple wire attached under the
screw head.
5. Remove the cradle, gasket, and shoulder washers.
Installation of new cradle assembly
1. Insert the new shoulder washers in the panel.
2. Assemble the new cradle and the new gasket to the panel with the new screws. Be sure to reattach the
purple wire under either of the screw heads.
Note: The purple wire should be between screw and shoulder washer, NOT between the chassis and
shoulder washer.
3. Reassemble the front panel to the chassis and tighten the four screws.
4. Place the amplifier in the enclosure.
5. Tighten the four front panel screws t to secure the amplifier.