GAI-Tronics 12576-115 Access Panel with VFD, 3x5 - Manual (Page 5)

Pub. 42004-635L2
Model 12576-115 Access Panel with VFD Page: 5 of 8
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-635l2.doc
02/98
Power
Connect the three-conductor ac power cord provided with the access panel as follows:
1. Loosen the captive screw on the connector lock of the three-prong power connector at the rear of the
access panel.
2. Plug one end of the power cord into the three-prong power connector at the rear of the access panel.
3. Tighten the captive screw in order to clamp the connector lock around the power cord. Plug the other
end into a grounded ac electrical outlet.
4. The access panel does not contain an internal power switch. The access panel will power up
immediately.
Push-Button Overlay
To install or replace the push button overlay, proceed as follows:
1. Loosen the eight mounting screws located along the edge of the existing push button overlay using a
1/16-inch Allen wrench or equivalent. Save these mounting screws.
2. Lift the existing push button overlay away from the access panel.
3. Mount the new push button overlay onto the access panel, aligning the screw-holes on the overlay
with those on the access panel.
4. Replace and tighten the eight mounting screws using a 1/16-inch Allen wrench or equivalent.