GAI-Tronics 10458-101 600-Ohm / RF Electronics Paging Module - Manual (Page 18)

Pub. 42004-415B
Model 10458-10x 600-Ohm/RF Electronics Paging Module Page 16 of 28
e:\standard ioms - current release\42004 instr. manuals\42004-415b.doc
03/15
RF Programming Software
Installation
Exit all other programs that are running until the installation is complete.
Place the CD in the computer CD-ROM drive. If the “auto-run” feature on your CD-ROM drive is
enabled, the CARD Suite menu screen should appear within a few seconds.
If the installation does not start up automatically, it can be run from the Start menu. Select the Start
button; then select Run. At the prompt, type x:\fscommand\setup.exe where x represents the drive
letter that is associated with your CD-ROM drive. A CARD Suite icon should appear on the desktop
display after successful installation.
Connecting the Programming Cable
1. Unplug the paging module’s 15-pin D-connector from the radio.
2. Connect the DTXP-PAC cable assembly’s 15-pin D-connector into the radio.
3. Connect the RJ11-style plug of the 9/RTC-PAS cable into the mating receptacle on DTXP-PAC
cable.
4. Connect the DB-9 to DB-25 adaptor to the other end of the 9/RTC-PAS cable.
5. Connect the DB-9 connector of the of the cable assembly to the computer serial port.
N OTE : If using a USB-to-RS-232 converter, connect the converter to the computer’s USB port and
then connect the cable to the 9-pin mating receptacle on the converter.
6. Connect the red and black leads of the 9/RTC-PAS cable to a 12 V dc source (battery or power
supply), observing the polarity (red +, black-).