GAI-Tronics 234L(x)-xxx LITE Series Stanchions - Manual (Page 17)

Pub. 42004-393B
Model 234L(x)-xxx LITE Series Stanchion Page: 16 of 18
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-393b.doc
03/07
Maintenance
Cleaning
The exterior of the GAI-Tronics LITE Series Stanchions can be cleaned with a soft, clean cloth or
nonabrasive soap or detergent and water. Dislodge any caked on dirt or mud by hand before wiping down
with a wet sponge or chamois. A build up of dirt or grit on the sponge, cloth, or chamois can cause
scratching to occur when cleaning. Be sure to use a clean cloth.
Grease and oil can be removed with kerosene or aliphatic naphtha (no aromatic content). Paint,
permanent marker, and pen can be removed with soap and water or isopropyl alcohol.
N OTE : Acrylic resin based paints cannot be removed.
NOTE
Do not use solvents such as acetone, benzene, carbon tetrachloride, fire extinguisher
fluid, dry-cleaning fluid, window cleaners, scouring compounds, and lacquer thinners on the LITE Series
Stanchion. These fluids will attack the stanchion main body.
Decal Repair
1. Using a very sharp instrument such as an X-Acto-type knife, loosen then lift a corner edge of the
damaged decal.
2. Carefully peel back and remove the loosened decal.
3. Wipe the area clean with isopropyl alcohol. Allow the area to dry.
4. Peel the backing from the replacement decal, leaving the decal attached to the front cover material,
and carefully align it with the target area.
5. With the cover material still attached, press the replacement decal in place, then squeegee any air
bubbles from under the new decal starting at the center and working toward the edges.
6. Peel off the cover material, being careful not to tear or lift the decal. If the decal lifts as the cover
material is being removed, push down on the uncovered decal, and squeegee as necessary to remove
any bubbles.