GAI-Tronics 234L(x)-xxx LITE Series Stanchions - Manual (Page 15)

Pub. 42004-393B
Model 234L(x)-xxx LITE Series Stanchion Page: 14 of 18
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-393b.doc
03/07
5. Place the back box into the phone opening from the front of the stanchion. Mount the box using the
eight 6-32 self-tapping flat head screws supplied in the stanchion’s parts envelope. Refer to Figure 9.
6. The telephone front panel is shipped from the factory with a cable and modular plug attached to TB1.
If the telephone line is to be hard-wired to the phone, this cable can be removed and discarded. Skip
to step 7. If desired, an optional modular telephone jack can be mounted to the inside of the back box
allowing the use of the cable and modular plug that is attached to TB1.
7. Bring the cable lead from the relay PCBA through the access hole of at the bottom of the back box for
connection to the telephone PCBA.
8. Attach the telephone’s cable lead to TB2 (out) on the telephone PCBA as shown in Figure 5.
9. Install the phone’s front panel using the six tamper-resistant screws and six washers provided with the
phone. Figure 9. Do not over-tighten. Excessive tightening will cause the panel to warp.
Figure 9. Telephone Installation