GAI-Tronics 530-001 L.E.D. Strobe with Constant-on Feature - Manual

Pub. 42004-395I
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374  800-492-1212  Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Model 530-001 LED Strobe with
Constant-On Feature
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive
business and technical information that is confidential and proprietary to GAI-Tronics. GAI-Tronics
retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
The Model 530-001 LED Strobe features an LED tower for constant-on and flashing operation with
secondary contacts for auxiliary equipment. The glow of the LED tower remains constant for area
location and flashes on and off, 240 flashes per minute, when activated by an emergency telephone.
The LED strobe is designed for top-of-pole mounting, wall mounting, or surface mounting.
The unit is equipped with a ¾-inch NPT female pipe thread in the base; a pipe nipple or conduit with a
corresponding thread should be used for mounting the units. For wall or surface mounting, the
GAI-Tronics Model 4115A Mounting Assembly Kit is recommended.
WARNING
Research indicates that a small portion of the general population,
( approximately 1 in 100,000) with Photosensitive Epilepsy (PSE) may experience
epileptiform seizures upon exposure to certain visual stimuli including lights flashing in
excess of 3Hz (180cpm). Individuals with positive photic response to visual stimuli who are
prone to seizures, such as persons with epilepsy, should avoid prolonged exposure to
environments in which flashing lights are activated.
Installation
CAUTION
These installation instructions are for use by qualified service personnel only.
 All field wiring to the beacon must meet the requirements of the National Electric Code (NEC) and
any other applicable local or state codes.
 Before beginning any installation or modification, be sure the main electrical disconnect switch is in
the OFF position. TAG THE DISCONNECT SWITCH WITH A SUITABLE WARNING LABEL.
 Electrical ground is required on this appliance.
 Improper connection of the equipment can result in electrical shock.