FSR SN-4100A User Manual

Page 2

PROPRIETARY INFORMATION

All information in this manual is proprietary to and the

property of FSR inc. This publication is protected by the Federal

of this document may be reproduced, transcribed, or transmitted,

in any form or by any means, without prior

explicit written permission from FSR inc.

Operators Safety Summary

The general safety information in this summary is for operating
personnel.

Do Not Remove Covers or Panels There are no user-serviceable
parts within the unit. Removal of the top cover will expose
dangerous voltages. To avoid personal injury, do not remove the
top cover. Do not operate the unit without the cover installed.
Power Source This product is intended to operate from a power
source that will not apply more than 230 volts rms between the
supply conductors or between both supply conductor and ground.
A protective ground connection by way of grounding conductor in
the power cord is essential for safe operation.
Grounding the Product This product is grounded through the
grounding conductor of the power cord. To avoid electrical shock,
plug the power cord into a properly wired receptacle before
connecting to the product input or output terminals. A protective-
ground connection by way of the grounding conductor in the power
cord is essential for safe operation.
Use the Proper Power Cord Use only the power cord and
connector specified for your product. Use only a power cord that is
in good condition. Refer cord and connector changes to qualified
service personnel.
Use the Proper Fuse To avoid fire hazard, use only the fuse having
identical type, voltage rating, and current rating characteristics.
Refer fuse replacement to qualified service personnel.
Do Not Operate in Explosive Atmospheres To avoid explosion,
do not operate this product in an explosive atmosphere.

IONS

SYNC INPUTS

Impedance:

470 ohms

Type:

TTL high noise immunity

Level:

1.9 volt minimum

SYNC OUTPUT

Impedance

75 Ohm

Level:

5 volts into Hi-Z, 2.4 Volts into 75 ohm load

Rise / Fall Time: 0.8 nS
Propagation

Delay: 17nS

POWER REQUIREMENTS

9 volts @ 400 mA (AC or DC).
A 9 VAC @ 1 AMP power adapter is included with two
pin Molex disconnect.

TECHNICAL SPECIFICAT

MOUNTING

Standard 19" Rack Mount Kit included

DB-9 Control I/O Pinout

PIN

FUNCTION

SWITCH 1 INPUT

SWITCH 3 INPUT

LAMP 1 OUTPUT

LAMP 3 OUTPUT

GROUND

SWITCH 2 INPUT

SWITCH 4 INPUT

LAMP 2 OUTPUT

LAMP 4 OUTPUT

VGA Connector15 pin High Density “D” connector

Connector may be reversed depending on which side is viewed.

Pin No. Function

1 Red Video

6 Red Ground 11 ID0 (Ground)

2 Green Video

7 Green Ground

12 ID1 (No Connect)

3 Blue Video

8 Blue Ground 13 Horizontal Sync

4 Reserved

9 No Connect 14 Vertical Sync

5 Ground

10 Ground

15 No Connect