FSR CDA-4/6 User Manual

Page 2

PROPRIETARY INFORMATION

All information in this manual is proprietary to and the

property of FSR inc. This publication is protected by the Federal

of this document may be reproduced, transcribed, or transmitted,

in any form or by any means, without prior

explicit written permission from FSR inc.

Operators Safety Summary

The general safety information in this summary is for operating
personnel.

Read Instructions Read and understand all safty and operating
instructions before using this equipment. Keep the instructions
handy.

Do Not Remove Covers or Panels There are no user-serviceable
parts within the unit. Removal of the top cover will expose
dangerous voltages. To avoid personal injury, do not remove the
top cover. Do not operate the unit without the cover installed.

Power Source This product is intended to operate from the
specifi ed wall plug-in transformer. Do not use any orther power
source.

Grounding the Product This product is grounded through the
grounding conductor of the power cord. To avoid electrical shock,
plug the power cord into a properly wired receptacle before
connecting to the product input or output terminals.

Use the Proper Power Cord Use only the power cord and
connector specifi ed for your product. Use only a power cord that is
in good condition. Refer cord and connector changes to qualifi ed
service personnel.

Do Not Operate in Explosive Atmospheres To avoid explosion,
do not operate this product in an explosive atmosphere.

Sync

Input level:

TTL 2.0V minimum

Output level:

5.0 Vp-p into Hi-Z, 2.4 Vp-p into 75 ohm

Delay Time:

8nS

Rise & Fall Time:

2.5nS

Input Impedance:

475 ohms

Output impedance:

75 ohms

Polarity:

Positive or negative

Horizontal frequency:

15 kHz - 200 kHz

Vertical frequency:

50 Hz - 150 Hz

General

Power:

120VAC, 50/60 Hz, 9 Watts, Wall plug-in with locking

connector
Enclosure:

Metal 8.5" W x 4.75" D x 1.62" H (1/2 rack unit).

Rack mounting kit is supplied.

Weight:

1.6 lbs.