FSR CB-224/224S - Manual (Page 2)

7. INSTALL 1RU TO 4RU x 19" EIA RACK-SIZED ELECTRONICS.
MAKE ELECTRICAL CONNECTIONS AS REQUIRED. RACK
MOUNT BRACKETS CAN BE RE-POSITIONED TO ALTERNATE
HOLES, OR ADDITIONAL BRACKETS MAY BE PURCHASED
(CB-224RKRL).
NOTE: MAXIMUM LOAD INSIDE CARRIAGE - 25 LBS
a
5. PULL DOWN DROP-DOWN RACK-MOUNT CARRIAGE TO MOUNT ELECTRONICS.
(a) PUSH LOCK ARM AWAY FROM POLE MOUNT AND (b) AND PULL DOWN ON
CHAIN. ONCE THE DROP-DOWN CARRIAGE IS PULLED FULLY DOWN (c) AGAIN
PUSH THE LOCK ARM AWAY FROM POLE MOUNT TO LOCK CARRIAGE IN THE
'DOWN' POSITION. REVERSE PROCEDURE TO RETRACT CARRIAGE BACK INTO
CEILING BOX.
NOTE: MAXIMUM LOAD INSIDE CARRIAGE - 25 LBS
MOUNTING ELECTRONICS INSTRUCTIONS
3. IF NOT INSTALLING FAN KIT, PROCEED TO STEP 5. IF INSTALLING FAN KIT,
REMOVE CEILING BOX DOOR. LOOSEN SCREWS TO OPEN DOOR. (a) PUSH
DOOR UP TOWARDS CEILING AND (b) PUSH TOWARDS DROP-DOWN
RACK-MOUNT CARRIAGE - REVERSE PROCEDURE TO INSTALL. DISCONNECT
SAFETY CABLE TO COMPLETELY REMOVE DOOR.
4. REMOVE #8-32 SCREW AS SHOWN, AND REMOVE OUTLET GRILL. SUPPORT
OUTLET GRILL WHILE REMOVING SCREW. INSTALL FAN KIT PER INSTRUCTIONS.
RE-INSTALL OUTLET GRILL AND CEILING BOX DOOR BACK INTO CEILING BOX BY
REVERSING THEIR REMOVAL STEPS.
LOCK ARM
DROP-DOWN
RACK-MOUNT
CARRIAGE
c
b
PULL CHAIN
(4) RACK
MOUNT
BRACKET
INCLUDED
ALTERNATE
RACK MOUNT
BRACKET HOLES
ALTERNATE/ADDITIONAL
RACK MOUNT BRACKET
HOLES ON OPPOSITE
SIDE OF CARRIAGE
VIEW SHOWING
ALTERNATE
BRACKET
HOLES USED
(2) #8-32 x 1/4-LONG
PAN HEAD SCREW
(2) WIRE
BUNDLE
INLET
(2) WIRE
INLET
FOAM
(2) WIRE
INLET
COVER
6. INSTALL WIRE BUNDLE INLET, WIRE
INLET FOAM, AND WIRE INLET COVER
TO SIDES OF BOX. REMOVE THE FOAM
BLOCKS NECESSARY FOR THE WIRE
BUNDLE EXITING THE BOX. PULL
WIRES TO CEILING BOX THRU WIRE
INLET OR CONDUIT AS REQUIRED.
LOOSEN SCREWS TO OPEN DOOR
DROP-DOWN
RACK-MOUNT
CARRIAGE
a
b
#8-32 x 1/4"-LONG
PAN HEAD SCREW
OUTLET GRILL
REMOVABLE
FOAM BLOCKS