FSR ML-116 - Manual (Page 29)

FSR
ML-116 INSTALLATION DATA
Telephone 973-785-4347 page 29
MAP PANEL (continued)
Explanation of MAP switch controls:
INTERLOCK SWITCH
This switch must be depressed (operated) in order to operate any switch on the MAP panel. It pre-
vents accidental operation.
MIX SWITCH
When any MIX switch is operated the associated LED illuminates indicating that those two areas
(rooms) are joined. In joining many rooms into one setup just keep operating the appropriate MIX
switches until the group is complete. To break apart a group of rooms just operate any of that groups'
MIX switches and the whole group will disband.
HEAD TABLE SWITCH
This switch, when operated, will cutout the speakers over that location whenever the mic's are active
and will reinstate those same speakers whenever the mic is preselected or off. This the same as
saying that the speakers are active when music is playing but shift to inactive when the mic is active.
This switch cannot be deactivated when the microphones are on.
Explanation of MAP LED operation:
MIX SWITCH LED's
These amber LED's illuminate when the two adjacent areas (rooms) are mixed.
HEAD TABLE LED's
These red LED's illuminate to indicate that the head table in that area(s) has been selected.
MICROPHONE LED's
These red LED's illuminate whenever a microphone (mixer) is either selected or is active.
LM (local mixer) LED's
These green LED's illuminate whenever the LM is selected or, in the case when the room is unmixed
it will automatically be illuminated since that mixer will be active.
MUSIC LED's
These green LED's illuminate whenever the music input is active (music is playing in the room).
MAP PANEL LOCKOUT LED
When this red LED illuminates it locks out the map panel. This will only happen if the Facility
Manager option is in place and it commanded a non-adjacent room be added to a group.