FSR ML-116 - Manual (Page 17)

FSR
ML-116 INSTALLATION DATA
Telephone 973-785-4347 page 17
Wall Plates
Size: 6 1/4 inches wide by 4 1/2 inches high, approximately 2.5 inches deep
Mounting: fits standard 2 or 3 gang electrical wall box with four or 6 screws
Switches: membrane
Connector: 5 pin connector
Cable: West Penn #3651 or 3751 (see page 13 for details)
Power Supply (PSA)
Size: 3 1/2 inch high, 6 inches deep, 10 inches long (approximately)
Mounting: rear rack rail
Input power: 105 to 132 VAC, 50/60 Hz, 100 watts
Output:
+15 volts, +25 volts, -25 volts nominal
Fuse: 2 amp
Switch: power on/off (lighted rocker switch)
Interconnect: 8 foot cable supplied, 5 conductor stranded
Indicators:
three LED indicators, one for each of the unregulated voltages
MON Monitor/VU Panel Assembly (optional)
Monitor/VU Panel
Input: 70Volt speaker level
Size: 19 inches wide, 5 1/4 inches high(3RU), 4 1/2 inches deep overall
Mounting: standard rack rails
Monitor Relay Card (supplied with the Monitor/VU card)
Size: 3 1/4 inches wide, 9 1/2 inches long, 1 inch high, comes already mounted in a
19 inch FSR TRAC-BRAC
Mounting: rear rack rails
MLH Head Table Speaker Assembly (optional)
Head Table Breakout Card (HTBC)
Size: 3 1/4 inches wide, 2 3/4 inches long, 1/2 inch high
Power: HT-PS supply provided
Head Table Relay Card (HT-8)
Size: 3 1/4 inches wide, 7 1/4 inches long, 1 inch high, can have up to four of these
cards per system
Mounting: rear rack rails, both the HTBC and the HT card come already mounted in a 19
inch FSR TRAC-BRAC
FM Facility Manager Control (optional)
Facility Managers Panel (FM-INT)
Size: an enclosed box 3 1/2 inches wide, 5 inches long, 1 1/2 inches high
Mounting: sits on the managers desk
Power: a wall mounted power supply