FSR ML-116 - Manual (Page 14)

page 14 Telephone 973-785-4347
FSR
ML-116 INSTALLATION DATA
J...The ML-116 regulator module accepts unregu-
lated DC voltages from the ML-116 PSA, power
supply. A plugable connection is provided to con-
nect to the power supply. LED indicators are pro-
vided to monitor the power within the unit.
K - L...The HTP module provides control inter-
face to support paging capabilities. It also provides
the control interface for the head table speaker
switching. Refer to sections titled Paging and Head
Table operation for additional details
M...Com 1 and Com2 update serial ports (DB-9 x
2 male)
N...Wallplate/monitor interface connectors. These
four points are where all room wallplates are con-
nected. The monitor panel, the remote map/moni-
tor and the ML-116-INT interface unit are con-
nected to one of these points. Four points are pro-
vided to ease system installation.
P...Facility managers panel interface connector.
Refer to section on this topic for additional details.
VU METER
MONITOR
SPEAKER VOLUME
CONTROL
DUPLICATES THE ROOM
WALLPLATE
ENABLE SWITCH
MUST BE DEPRESSED
TO OPERATE ANY
SWITCH ON THE
ROOM PANEL
SPEAKER
MONITOR/VU PANEL
SELECTS THE ROOM OR EX-
TERNAL ZONE TO BE MONI-
TORED
Monitor/VU Panel Installation
While the Monitor/VU panel is optional, it is recommended for all systems comprising more than six
rooms. The installation of this feature requires the Monitor Relay Card in addition to the above
panel. This relay card is supplied mounted in an FSR TRAC-BRAC simplifying the rear rack mount-
ing of this card.