Foxconn P35A - Manual (Page 49)

3
42
Hardware Health Configure
► Fan 1 Mode Setting (CPU FAN)
This item is used to support SMART CPU FAN feature which allows system to adjust its fan
speed according to CPU temperature. The lower the CPU temperature, the slower the FAN
speed. The options of this setting are :
Auto fan by RPM :
Control CPU FAN by delivering a PWM signal, which supports SMART FAN feature. You
must use 4-wire FAN for this setting. Also, if you are using 3-wire CPU FAN, we recommend
you to choose this setting so it can run at its full speed.
Auto fan by DutyCycle :
Control CPU FAN by using linear voltage, only supports 3-wire CPU FAN. DO NOT
recommend to use this setting for 3-wire CPU FAN, as some old 3-wire FANs may fail to run
by this setting.
Manual fan by RPM :
Manually fix 4-wire CPU FAN running at one particular speed.
Manual fan by DutyCycle :
Manually fix 3-wire CPU Fan running at one particular speed based on a percentage ratio to
the maximum speed. DO NOT recommend.
► Temperature 1 Limit of Highest / Second / Third / Lowest
These items are used to set the CPU temperature limit. When CPU detects itself staying at the
highest temperature, system will drive CPU FAN to run at its maximum speed.
► Fan 1 Highest / Second / Third / Fourth / Lowest Setting
These items are used to set the different levels of the fan speed, 100 is its maximum speed.
► CPU Temperature / System Temperature / CPU Fan Speed / System Fan Speed /
Vcore / 1.8V SUS / 1.2V CoRe / +5V / +12V / +3.3V / VCC / VSb / VbAT
These items display the information of current CPU / chipset / system temperature, fan speeds
and voltages, all these messages are automatically detected and displayed by the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Hardware Health Configure
Hardware Health Configure ▲ Help Item
█
FAN 1 Mode Setting [Auto Fan by RPM] █ Fan configuration
Temperature 1 Limit of Hig [050] █ mode setting
Temperature 1 Limit of Sec [040] █
Temperature 1 Limit of Thi [030] █
Temperature 1 Limit of Low [020] █
Fan 1 Highest setting [100] █
Fan 1 Second setting [080] █
Fan 1 Third setting [070] █
Fan 1 Fourth setting [060] █
Fan 1 Lowest setting [050] █
CPU Temperature :44°C/111°F █
SYS Temperature :40°C/104°F █
CPU Fan Speed :1174 RPM ▒
SYSTEM Fan Speed :N/A ▒
Vcore :1.304 V ▼
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F7:Previous Values F8:Fail-Safe Defaults F9:Optimized Defaults
[Auto Fan by RPM]