Foxconn P35A - Manual (Page 23)

2
16
front Panel Connector : fP1
This motherboard includes one connector for connecting the
front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indicator LED. It
indicates the active status of the hard disks. This 2-pin
connector is directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the switch
is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front panel
of the chassis. The Power LED indicates the system’s
status. When the system is in operation (S0 status), the
LED is on. When the system gets into sleep mode (S1) ,
the LED is blinking; When the system is in S3/S4 sleep
state or power off mode (S5), the LED is off. This 2-pin
connector is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of the
chassis. Push this switch allows the system to be turned
on and off rather than using the power supply button.
IrDA Connector : IR
This connector supports wireless transmitting and receiving
device.
1394a Connector : f_1394 (P35A-S only)
The 1394a expansion cable can be connected to either
the front (provided that the front panel of your chassis is
equipped with the appropriate interface) or real panel of the
chassis.
Audio Connector : f_AUDIo
The audio connector supports HD Audio standard. It provides
the Front Audio output choice.
CoM Connector : CoM1
This motherboard supports another serial RS232 COM port
for legacy compatibility. User must purchase a RS232 cable
1 +5V
EMPTY
IRRX
GND
IRTX
IR
HDD-LED
RESET-SW
NC
+
-
PWR-SW
+
-
PWR-LED
EMPTY
1 2
10 9
FP1
SENSE1_RETURN
PRESENCEJ
EMPTY
SENSE2_RETURN
AUD_GND
1 2
10 9
F_AUDIO
PORT1_L
PORT1_R
PORT2_L
PORT2_R
SENSE_SEND
GND
+12V
TPA-
TPB-
GND
TPB+
+12V
GND
TPA+
EMPTY
1 2
10 9
F_1394