Foxconn P35A - Manual (Page 42)

3
35
► AHCI Configuration
When your motherboard supports AHCI, and you also set SATA Mode setting to [AHCI] or
[RAID], then [Press Enter], you can read the drive information of at most six SATA devices
from here.
► Primary/Secondary IDE Master, Third/Fourth/Fifth/Sixth IDE Master/Slave
While entering setup, BIOS automatically detects the presence of IDE devices. This item
displays the drive information of IDE devices. The display information only applies when SATA
Mode Select is set to [IDE] mode.
► IDE Detect Time Out (Sec)
This item is used to select the time out value for detecting ATA/ATAPI devices. If the checking
time is over the set value, the system will skip it.
SuperIO Configuration
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port 1/2 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port .
Note: Do not try to set the same values for serial ports 1 and 2.
► Serial Port2 Mode
This item is used to set the serial Port2 mode. The available settings are :
[Normal]; [IrDA 1.6us]; [IrDA 3/16 bit].
► Parallel Port Address
This item is used to assign the base address for the onboard parallel port.
► Parallel Port Mode
This item is used to set the transmission mode of the parallel port. They are :
Normal, Bi-Directional, ECP, EPP and ECP/EPP.
► Parallel Port IRQ
This item is used to determine onboard parallel port IRQ.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
SuperIO Configuration
Configure F71882F Super IO Chipset Help Item
OnBoard Floppy Controller [Enabled] Allows BIOS to Enable
Serial Port1 Address [3F8/IRQ4] or Disable Floppy
Serial Port2 Address [2F8/IRQ3] Controller
Serial Port2 Mode [Normal]
Parallel Port Address [378]
Parallel Port Mode [Normal]
Parallel Port IRQ [IRQ7]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F7:Previous Values F8:Fail-Safe Defaults F9:Optimized Defaults
[Enabled]