Fluke Biomedical HHC3 - Manual (Page 5)

Returns for partial refund/credit:
Every product returned for refund/credit must be accompanied by a Return Material Authoriza-
tion (RMA) number, obtained from our Order Entry Group at 1-800-648-7952 or 1-425-446-
6945.
Repair and calibration:
To find the nearest service center, go to
www.flukebiomedical.com/service or
In the U.S.A.:
Cleveland Calibration Lab
Tel: 1-800-850-4606
Email: [email protected]
Everett Calibration Lab
Tel: 1-800-850-4606
Email: [email protected]
In Europe, Middle East, and Africa:
Eindhoven Calibration Lab
Tel: +31-402-675300
Email: [email protected]
In Asia:
Everett Calibration Lab
Tel: +425-446-6945
Email: [email protected]
Certification
This instrument was thoroughly tested and inspected. It was found to meet Fluke Biomedical’s
manufacturing specifications when it was shipped from the factory. Calibration measurements
are traceable to the National Institute of Standards and Technology (NIST). Devices for which
there are no NIST calibration standards are measured against in-house performance standards us-
ing accepted test procedures.
WARNING
Unauthorized user modifications or application beyond the published specifications may result in
electrical shock hazards or improper operation. Fluke Biomedical will not be responsible for any
injuries sustained due to unauthorized equipment modifications.
Restrictions and Liabilities
Information in this document is subject to change and does not represent a commitment
by Fluke Biomedical. Changes made to the information in this document will be incorpo-
rated in new editions of the publication. No responsibility is assumed by Fluke Biomedi-
cal for the use or reliability of software or equipment that is not supplied by Fluke Bio-
medical, or by its affiliated dealers.
Manufacturing Location
The HHC3 Hand Held Controller is manufactured in India for Fluke Biomedical, 6920 Seaway Blvd.,
Everett, WA, U.S.A.