Fluke Biomedical 945A - Manual (Page 17)

Section 2 - Receiving Inspection and Storage
Receiving Inspection
Upon receipt of the unit:
1. Inspect the carton(s) and contents for damage. If damage is evident, file a claim with the carrier and
notify the Victoreen Customer Service Department.
Fluke Biomedical RMS
6045 Cochran Rd.
Cleveland. Ohio 44139
Phone: (440) 248-9300
Fax: (440) 349-2307
2. Remove the contents from the packing material.
3. Verify that all items listed on the packing list have been received and are in good condition.
NOTE
If any of the listed items are missing or damaged, notify the Fluke
Biomedical RMS Customer Service Department.
Storage
Storage of Fluke Biomedical RMS instruments must comply with Level B storage requirements as
outlined in ANSI N45.2.2 (1972) Section 6.1.2(.2). The storage area shall comply with ANSI N45.2.2
(1972) Section 6.2 Storage Area, Paragraphs 6.2.1 through 6.2.5. Housekeeping shall conform to ANSI
N45.2.3 (1972).
Level B components shall be stored within a fire resistant, tear resistant, weather tight enclosure, in a well
ventilated building or equivalent.
Storage of Fluke Biomedical RMS instruments must comply with the following:
1. Inspection and examination of items in storage must be in accordance with ANSI N45.2.2
(1972)
Section 6.4.1.
2. Requirements for proper storage must be documented and written procedures or instructions
must be established.
3. In the event of fire, post-fire evaluation must be in accordance with ANSI N45.2.2
(1972),Section
6.4.3.
4. Removal of items from storage must be in accordance with ANSI N45.2.2 (1972),
Sections 6.5
and 6.6.
2-1