Flowserve URB 2 - Manual (Page 19)

9
Baud rate
250kBd
125kBd
old:
new:
Used baud rate
Brightness
Background illumination
MIN MAX
Contrast of the screen
MIN MAX
Menu Start
– continued –
Baud rate
. Check the baud rate of the connected equipment.
If necessary adapt the baud rate of the URB 2 to
the baud rate setting of the CAN bus.
2. To set the parameters press button . The
activated item is shown in the symbol bar. The
background of the selected item is flashing.
3. To enter a new value turn the navigation wheel and
confirm the input by pressing the navigation wheel.
The flashing stops.
Brightness
. To set the individual parameters press button
. The activated item is shown in the symbol
bar.
2. To set the desired parameter turn the navigation
wheel and confirm the input by pressing the
navigation wheel. The background of the selected
item is flashing.
3. To enter a new value turn the navigation wheel
and confirm the input by pressing the navigation
wheel. The flashing stops.
4. To obtain more available elements repeat items 2
and 3 and press button .
Note
Make sure that all bus nodes feature the same baud rate settings.
If a baud rate setting is incorrect an acoustic signal will be given.