Flowserve CEA Series Limitorque Automax - Manual (Page 18)

Limitorque Worcester Controls CEA Series FCD WCENIM2080-00-AQ 12/14
18
BASIC MENU
READ
Values can be read using the Read Menu and some values can be
reset.
READ
pos
READ
set&pos
READ
torque
READ
motor temp
READ
comp temp
Statistics
n cycles
Statistics
mean dev
Statistics
acc travel
Statistics
# of reset
Statistics
run time
Statistics
extreme temp
READ
statistics
Pos shows current position
Set & pos shows current setpoint
and position
Set & dev shows current setpoint
and deviation
Torque shows current load torque
Motor temp shows current motor temp
Compa temp shows current compartment temp
Statistics
shows statistics and
diagnostic data
Statistics
n cycles
Shows number of movements
(turns)
Acc travel
Shows accumulated
movement
mean dev
Shows accumulated deviation in %
runtime Shows accumulated runtime
since last reset
Extr temp Shows extreme min and max
temperature
Histogram
Shows position and time for
PV
Alarms
Displays tripped alarms
READ
set&dev
Statistics
histogram
Statistics
pos graph
Statistics
reset stats
Statistics
diagnostics
BASIC MENU
MAN / AUTO
The Man/Auto menu is used to change between manual and automatic
modes.
AUT, OK = MAN
Positioner in automatic mode
MAN, OK = AUT
Positioner in manual mode
In the MAN mode, the value of POS can be changed using the UP/
DN push buttons. The push-buttons increase/decrease the value in
steps. The value can also be changed in the same way as for the other
parameter values, as described on page 14.
AUT, OK=MAN
POS= 12.3%
OK MAN, OK=AUT
POS= 12.3%
When changing between
MAN and AUT mode, the OK
button must be pressed for 3
seconds.