Flowserve CEA Series Limitorque Automax - Manual (Page 17)

17
Limitorque Worcester Controls CEA Series FCD WCENIM2080-00-AQ 12/14
flowserve.com
BASIC MENU /
STATUS
The Status Menu is used to select whether or not the actuator is in
service.
o o service Not in service. Flashing indicator in upper
left-hand corner of display.
in service Positioner in service.
Critical parameters cannot be changed.
When changing between
In service and Out of Service,
the OK button must be
pressed for 3 seconds.
OK
STATUS
O O service
STATUS
in service
OK
OK OK
BASIC MENU /
PROTECTION
The Write Protect menu is used to protect all essential settings.
No Entered values are not write protected.
”Unprotected” is displayed in the lower
left-hand corner.
Yes Entered values are write protected. Passcode
needed for change to No (Applicable when a passcode has
been set up in SETUP menu).
When changing between
Yes and No mode, the OK
button must be pressed
for 3 seconds.
PROTECTION
yes
PROTECTION
no
OK
OK OK
OK
BASIC MENU
SHIFT MENU
The Shift Menu is used to choose between the basic menu and the full
menu.
The menu contents are shown in the figures on the right and the
various texts are described below:
No Full menu selected.
Yes Basic menu selected.
Full Menu can be locked with a
passcode, see Setup menu.
OK
OK
Full menu
no
Full menu
yes
OK
OK